BONDO/MAR-HYDE CORP -- 902, 9027 BLACK PLASTIC RUBBER NEOPRENE RUBBER SEALER -- 8040-01-343-2991 
=====================  Product Identification  =====================

Product ID:902, 9027 BLACK PLASTIC RUBBER NEOPRENE RUBBER SEALER
MSDS Date:02/19/1995
FSC:8040
NIIN:01-343-2991
Status Code:A
=== Responsible Party ===
Company Name:BONDO/MAR-HYDE CORP
Address:3700 ATLANTA INDUSTRIAL PKWY NW
City:ATLANTA
State:GA
ZIP:30331
Country:US
Info Phone Num:404-696-2730
Emergency Phone Num:404-696-2730
Preparer's Name:ERNEST CARTER
Chemtrec Ind/Phone:(800)424-9300
CAGE:16522
=== Contractor Identification ===
Company Name:BONDO/MAR-HYDE CORP
Address:3700 ATLANTA INDUSTRIAL PKWY NW
Box:City:ATLANTA
State:GA
ZIP:30331
Country:US
Phone:404-696-2730
CAGE:16522

=============  Composition/Information on Ingredients  =============

Ingred Name:SOLVENT BLEND
< Wt:75.

Ingred Name:TOLUENE
CAS:108-88-3
RTECS #:XS5250000
OSHA PEL:SEE TABLE Z-2
ACGIH TLV:188 MG/M3;50 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:LACTOL SPIRITS

Ingred Name:XYLENE
CAS:1330-20-7
RTECS #:ZE2100000
ACGIH TLV:434 MG/M3;100 PPM
ACGIH STEL:651 MG/M3;150 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:ACETONE
CAS:67-64-1
RTECS #:AL3150000
OSHA PEL:2400 MG/M3;1000 PPM
ACGIH TLV:1780 MG/M3;750 PPM
ACGIH STEL:2380 MG/M3;1000 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

=====================  Hazards Identification  =====================

Health Hazards Acute and Chronic:EXCESSIVE INHALATION CAUSES HEADACHE,
    DIZZINESS AND NAUSEA.ANESTHESIA IN VERY HIGH CONCENTRATIONS. CAN
    CAUSE IRRITATION TO NOSE, THROAT, EYES, AND SKIN. CHRONIC: REPORTS
    HAVE ASSOCIATED PROLONGED AND  REPEATED OVEREXPOSURE TO SOLVENTS
    WITH PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE.
Medical Cond Aggravated by Exposure:PREEXISTING SKIN, RESPIRATORY,
    CENTRAL NERVOUS SYSTEM, LIVER, AND KIDNEY DISORDERS.

=======================  First Aid Measures  =======================

First Aid:EYES: FLUSH WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES.IF
    IRRITATION PERSISTS, CALL A PHYSICIAN.SKIN: WASH THOROUGHLY WITH
    SOAP AND WATER.REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE
    REUSE. APPLY  SKIN CREAM.INHALATION: REMOVE TO FRESH AIR.IF
    BREATHING IS DIFFICULT , ADMINISTER OXYGEN, IF BREATHING HAS
    STOPPED. GIVE ARTIFICIAL RESPIRATION.    INGESTION: DO NOT INDUCE
    VOMITING. CALL A PHYSICIAN	IMMEDIATELY.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:=-17.2C, 1.F
Lower Limits:1.0%
Upper Limits:13.0%
Extinguishing Media:DRY POWDER, FOAM, CO2.
Fire Fighting Procedures:DO NOT USE UNLESS SPECIAL FOGGING SYSTEMS.
Unusual Fire/Explosion Hazard:VAPORS MAY CAUSE FLASH FIRES. VAPORS MAY
    IGNITE EXPLOSIVELY. IF IN CLOSED CONTAINERS, HEAT WILL CAUSE
    BUILDUP OF PRESSURE. WATER CAN BE USED TO COOL CONTAINERS.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE SPARKS, FLAMES, OR HOT SURFACES. USE
    ADEQUATE VENTILATION.AVOID BREATHING OF VAPORS. CLEAN UP WITH
    NON-SPARKING TOOLS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP OUT OF REACH OF CHILDREN.DO NOT
    SMOKE. EXTINGUISH ALL FLAMES AND PILOT LIGHTS AND TURN OFF STOVES,
    HEATERS, ELECTRIC MOTORS, AND ALL OTHER SOURCES OF IGNITION DURING
    USE AND UNTIL ALL VAPORS ARE  GONE. CLOSE CONTAINER AFTER EACH USE.
Other Precautions:VAPORS MAY CAUSE FLASH FIRE. VAPORS MAY IGNITE
    EXPLOSIVELY. VAPORS HARMFUL. AVOID PROLONGED CONTACT WITH SKIN. MAY
    BE HARMFUL OR FATAL IF SWALLOWED. KEEP AWAY FROM FIRE, HEAT AND
    OPEN FLAMES.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE IN WELL VENTILATED AREA.
Ventilation:LOCAL EXHAUST IN SUFFICIENT VOLUME AND PATTERN TO MAINTAIN
    TLVS BELOW STATED LIMITS.
Protective Gloves:USE SOLVENT RESISTANT GLOVES SUCH AS NITRILE RUBBER.
Eye Protection:SAFETY GLASSES WITH SIDESHIELDS.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:=98.9C, 210.F
Vapor Pres:38 068 DEG F
Vapor Density:HEAVIER
Spec Gravity:1.0
Evaporation Rate & Reference:3.8-2.7
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK/TOLUENE ODOR

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT, SPARKS AND OPEN FLAME.
Hazardous Decomposition Products:CARBON DIOXIDE, CARBON MONOXIDE,
    VARIOUS HYDROCARBONS, HCL.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH FEDERAL, STATE AND
    LOCAL REGULATIONS.

=====================  Regulatory Information  =====================

SARA Title III Information:TOLUENE, XYLENE AND ACETONE ARE SARA TOXIC
    CHEMICALS AND ARESUBJECT TO THE REPORTING REQUIREMENTS OF SECTION
    313 TITLE III OF THE SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT
    OF 1986 AND  40 CFR PART  372.
State Regulatory Information:THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO
    THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS OR OTHER
    REPRODUCTIVE HARM.

=======================  Other Information  =======================

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.